Position Sensors Required
The feature you selected needs an Atlantis Position Sensor (APS) that has been installed and set up. APS lets the controller measure lift height and use saved positions.
Before you continue
Ask your installer to check the setup
Do not change the sensor settings to clear this message. Selecting APS in the settings does not install a sensor or make it ready to use.
What to do
- 1
If saved positions worked before
Take a screenshot of the message and contact your installer. The sensor or its setup may need attention.
- 2
If your lift has never used saved positions
Ask your dealer whether your lift supports an APS upgrade. Physical limit switches can stop the lift at the top and bottom, but they do not provide saved height presets.
- 3
If you need to move the lift
Use only the controls your installer has shown you. Make sure AUTO is off, keep the lift in sight, then hold UP or DOWN to move and release to stop. Follow any other warning shown in the app.
Was this article helpful?
Tell us whether this answered your question.