Atlantis Lift Support
Limits Required for Auto
Auto needs a working stopping system so the lift knows where to stop. This message means that stopping protection is not enabled for the requested move.
Before you continue
Leave Auto off until the setup is checked
Do not change a setting just to remove this message. Your installer must confirm the equipment and test both stopping points.
01
The stopping systems
- Physical limit switches stop the lift at the top and bottom. Once installed and tested, they can support Auto movement between those stops.
- Atlantis Position Sensor (APS) measures lift height. Once installed and set up, it supports top and bottom stops and saved height presets.
- Manual (no limit switches) requires you to hold the movement control and release it to stop. It does not provide automatic stopping at a saved top or bottom position. The movement timer is a backup time limit, not a height measurement.
02
What to do
- 1
Save the message
Take a screenshot and tell your installer whether Auto worked before.
- 2
Use only approved manual controls
If your installer has shown you how to use Manual, make sure AUTO is off. Keep the lift in sight, hold UP or DOWN to move, and release to stop. Follow any other warning shown.
- 3
Ask your installer to check the lift
They can confirm the correct stopping system and finish any required setup.
Was this article helpful?
Tell us whether this answered your question.

