Motor Stall
The lift did not move normally when a motor was running, so the controller stopped it. An obstruction, uneven load, mechanical problem, or electrical fault may be preventing movement.
Before you continue
Release the control and inspect the lift
Turn the key OFF. Do not keep trying a lift that hums, binds, tilts, smells hot, or has a motor that does not move. Repeated attempts can overheat equipment or make an unsafe condition worse.
Common causes
- The boat or cradle is overloaded, unbalanced, or caught on an obstruction.
- A cable, pulley, drum, bearing, gearbox, or motor is damaged or binding.
- A motor or its electrical supply has a fault.
- The lift moves, but its position sensor is loose, damaged, or not reading movement.
What to do now
- 1
Make the area safe
Keep people clear of the lift and never go under a suspended boat or cradle.
- 2
Look from a safe distance
Note any visible obstruction, uneven side, loose cable, motor that did not move, unusual sound, odor, or smoke. Do not touch damaged equipment.
- 3
Record what happened
Tell your dealer which direction you selected, which parts moved, and whether the motor hummed or stopped suddenly. Include a photo of the warning.
- 4
Arrange service before retrying
A qualified lift technician should find and repair the mechanical, electrical, or position-sensor problem before testing movement.
Was this article helpful?
Your feedback helps us improve our support resources